RadioLink T8fb Instruction Manuall LINK
Click Here > https://tiurll.com/2tvXaJ
```html
How to Use the RadioLink T8fb Instruction Manual
The RadioLink T8fb is a versatile and reliable 8-channel transmitter that can be used for various RC models, such as planes, helicopters, drones, cars, boats, etc. It features a 2.4 GHz FHSS system that ensures a stable and interference-free connection with the receiver. It also supports multiple battery options, low voltage alarm, data backup, and firmware update.
If you are looking for a comprehensive guide on how to use the RadioLink T8fb instruction manual, you have come to the right place. In this article, we will show you how to set up your transmitter, bind it with the receiver, adjust the parameters, and troubleshoot some common issues. We will also provide you with some useful tips and resources to help you get the most out of your RadioLink T8fb.
How to Set Up Your RadioLink T8fb Transmitter
Before you start using your RadioLink T8fb transmitter, you need to do some basic preparations. Here are the steps you need to follow:
Install the battery. You can use 4 AA batteries or a 2S to 4S LiPo battery with a JST connector. Make sure the polarity is correct and the battery is fully charged.
Turn on the transmitter by pressing and holding the power button for 3 seconds. You will hear a beep sound and see the LED indicator turn green.
Select the mode. The transmitter has two modes: mode 1 (throttle on the right stick) and mode 2 (throttle on the left stick). You can switch between them by pressing and holding the power button and SwB at the same time for 3 seconds. You will hear two beeps for mode 1 and one beep for mode 2.
Adjust the trimmers. The transmitter has four trimmers: Throttle Trim (T-TRIM), Aileron Trim (A-TRIM), Elevator Trim (E-TRIM), and Rudder Trim (R-TRIM). You can use them to fine-tune the neutral position of each channel. To adjust a trimmer, press it up or down until you hear a beep sound.
How to Bind Your RadioLink T8fb Transmitter with the Receiver
The RadioLink T8fb transmitter is compatible with various receivers, such as R12DS, R12DSM, R9DS, R6DS, R6DSM, R8EF, R8XM, R8FM, R8SM, R8F, R8FG, R7FG, R6FG, R6F, R4FGM, R4F, etc. To bind your transmitter with the receiver, you need to follow these steps:
Connect the receiver to the power source and plug a servo or an ESC into any channel.
Press and hold the ID SET button on the receiver for 2 seconds until you see the LED indicator flash red rapidly.
Turn on the transmitter within 1 meter of the receiver. You will hear a long beep sound and see the LED indicator turn solid green on both devices.
Check if the servo or ESC responds to your transmitter commands. If yes, then the binding is successful. If not, then repeat the steps above.
How to Adjust the Parameters of Your RadioLink T8fb Transmitter
The RadioLink T8fb transmitter allows you to adjust some parameters using a PC software or a mobile app. You can download them from https://www.radiolink.com/t8fb_bt_firmwares. You can use them to set up functions such as dual rates, exponential curves, mixing control, channel reversing, subtrim, end point adjustment, fail-safe mode, etc.
To connect your transmitter to your PC or mobile device, you need a USB cable or a Bluetooth module (sold separately). Here are the steps you need to follow:
Turn on your transmitter and connect it to your PC or mobile device using a USB cable or a Bluetooth module.
Launch the PC software or mobile app and select your device model (T8FB).
Select the COM port or Bluetooth aa16f39245